Spot00008.pngDrawing cable paths

Tool

Tool set

Cable Path

Cable_Path_tool.png 

Preview

Typically, an event space has one area where power and signal cables start from for each department. Then, there are one or two fixed paths from this location to the roof, to trusses, to speakers, etc., which break out to the different areas.

A cable path is considered a load, and can be included in load calculations (Braceworks required); the object could be used to represent a cable load in preliminary designs by assigning it a Weight value.

In any view, the Cable Path tool draws a 3D cable path as a template for future cables. By inserting a cable path object, you can avoid redrawing the same path for multiple cable runs; the Cable tool can use the path when placing cables.

Cable_Path_modes.png 

Mode

Description

Polyline creation options

Selects the method for drawing the polyline upon which the object is based; see Polylijnen tekenen

Fillet Radius

For Arc Vertex polyline mode, enter the fillet radius

Automatic Numbering

Enables automatic numbering of cable areas as they are placed

Numbering Preferences

Set the default parameters for automatic numbering of cable areas

To draw a cable path:

1.      Click the tool. From the Tool bar, enable Automatic Numbering if desired, and specify the Numbering Preferences. See Automatic numbering preferences.

2.Select a drawing mode from the Tool bar.

3.Click to set the cable path’s start point.

4.Click to set the end of the segment and the beginning of the next. As you place the cable path, compatible objects such as distributors and trusses are highlighted; click to connect (see Concept: Attaching loads to rigging objects). Continue drawing segments in this manner and double-click when the path is complete.

5.When inserting cables with the Cable tool, click on the cable path object to automatically create the cable run based on the path.

The parameters can be edited later from the Object Info palette.

Use the Reshape tool to change the route of the cable path; double-click on the cable path to activate the Reshape tool, or right-click on the object and select Edit Path.

~~~~~~~~~~~~~~~~~~~~~~~~~

Inserting cables

Setting cable preferences

Preview cable suite